To replace the front bushing of the lower Control Arm, first unscrew the front drive axle in case it has been equipped. Then, take out the lower Control Arm. Before you remove the bushing, take its distance from the bushing flange to the bracket and note it down because this will decide the installation depth for a new bushing. Use j 41805 ball joint remover/ installer (J 41805) to remove the rear bushing. For installation, again, use the j 41805 ball joint remover/installer (J 41805) to install the rear bushing, make sure it is placed at the predetermined measurement as shown earlier. Lastly, replace the lower Control Arm and the front drive axle, in case it was installed.