How to Remove and Replace the Air Bag Clockspring Assembly on Chevrolet Impala?

To replace and remove the air bag clock spring assembly / spiral cable, turn off the sir system. With the vehicle wheels straight ahead, use vehicle's steering column anti-rotation pin (J42640), steering column lock, or strap to prevent its spinning which will prevent damage and possible sir system malfunction. Make sure that the Steering Wheel does not open before disconnecting the steering column, intermediate shaft(s), and steering gear. After isolating these components, do not twist the Steering Wheel or shift the front tires and wheels in order to avoid the possibility of the sir coil assembly going off-center. Ensure the wheels are straight ahead and j 42640 is installed or the ignition switch is in the lock position. Pull the Steering Wheel off the shaft on vehicles with a tilt steering column, pull the tilt lever straight out, then take out the 2 torx(R) head screws holding the lower trim cover, and then the two torx(R) head screws on the upper trim cover. Pull off the wire harness straps from the Steering Wheel column wire harness as well as the retaining ring so as to remove off the sir coil from the Steering Shaft. In case of replacing, throw away the old sir coil. For installation, make sure that the new sir coil assembly is centered, and never take out the centering tab before installation is over. If recycling the same coil, it must be centralized. Set the sir coil assembly parallel to the horn tower on the turn signal cancel cam assembly, slide the sir coil onto the Steering Shaft assembly and the retaining ring firmly seated into the groove on the Steering Shaft assembly. The centering tab must be removed and thrown out from the new sir coil. Install the upper trim cover using 2 torx (r) head screws and tighten to 1.5-nm (13 lb in), and the lower trim cover with two torx (r)'s head screws and ensure the tab on the lower trim cover clicks into the upper trim cover before tightening the screws. When using a tilt column, position the tilt lever handle in the steering column and slide it till it locks into position. Finally, mount the Steering Wheel on the Steering Shaft and activate the sir system.

OEM Chevrolet Impala Air Bag Clockspring

Steering Wheel Airbag Coil

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

9 Air Bag Clocksprings found

View related parts
Chevrolet Impala Clockspring Part Number: 84335791
$98.37 MSRP: $146.38
You Save: $48.01 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Coil Assembly-Steering Wheel Airbag; Air Bag Clockspring; Coil, Inflatable Restraint System
- Replaces: 23418085
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2014-2020 Chevrolet Impala | Eco, LS, LT, LTZ, Premier | 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 4 Cyl 2.5 L FLEX, 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L BI-FUEL, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Impala Clockspring Part Number: 84335790
$98.37 MSRP: $146.38
You Save: $48.01 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Coil Assembly-Steering Wheel Airbag; Air Bag Clockspring; Coil, Inflatable Restraint System
- Replaces: 23418084
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2017-2020 Chevrolet Impala | LS, LT, Premier | 4 Cyl 2.5 L FLEX, 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L BI-FUEL, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Impala Clockspring Part Number: 23354426
$79.08 MSRP: $150.83
You Save: $71.75 (48%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Coil Assembly-Steering Wheel Airbag; Air Bag Clockspring; Coil, Inflatable Restraint System
- Replaces: 23103877, 23182478
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2014-2017 Chevrolet Impala | Eco, LS, LT, LTZ, Premier | 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 4 Cyl 2.5 L FLEX, 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L BI-FUEL, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Impala Clockspring Part Number: 23103878
$64.96 MSRP: $96.67
You Save: $31.71 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Coil Assembly-Steering Wheel Airbag; Air Bag Clockspring; Coil, Inflatable Restraint System
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2014 Chevrolet Impala | Eco, LS, LT, LTZ | 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Impala Clockspring Part Number: 19258035
$279.90 MSRP: $418.39
You Save: $138.49 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Coil Kit, Inflatable Restraint Steering Wheel Module; Air Bag Clockspring; Coil Kit, Inflatable Restraint System
- Replaces: 19133679, 19179708
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2006-2013 Chevrolet Impala | 50th Anniversary Edition, LS, LT, LTZ, Police, SS | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
View related parts
Chevrolet Impala Clockspring Part Number: 26089982
Product Specifications
- Other Name: Coil Kit, Inflatable Restraint System; Air Bag Clockspring
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2001-2005 Chevrolet Impala | Base, LS, LS Sport, SS | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
View related parts
Chevrolet Impala Coil Assembly Part Number: 26041005
Product Specifications
- Other Name: Coil Kit, Inflatable Restraint Steering Wheel Module; Air Bag Clockspring; Coil; Clockspring; Coil Kit, Inflatable Restraint System
- Replaces: 26053264
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1994-1996 Chevrolet Impala | SS | 8 Cyl 5.7 L GAS
View related parts
Chevrolet Impala Clockspring Part Number: 26087296
Product Specifications
- Other Name: Coil Kit, Inflatable Restraint System; Air Bag Clockspring; Coil, Inflatable Restraint System
- Replaces: 26070064
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2000 Chevrolet Impala | Base, LS | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
View related parts
Chevrolet Impala Clockspring Part Number: 19133680
Product Specifications
- Other Name: Coil Kit, Inflator Restraint Steering Wheel Module; Air Bag Clockspring; Coil Kit, Inflatable Restraint System
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2006 Chevrolet Impala | LS, LT, LTZ, Police, SS | 6 Cyl 3.5 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS

Chevrolet Impala Air Bag Clockspring

Want to cut long-term maintenance and repair costs? Choose OEM Air Bag Clockspring. Those parts deliver top durability you can trust. On our site, you'll find a huge catalog of genuine Chevrolet Impala parts. Prices are unbeatable, so you can keep more in your pocket. Every OEM Chevrolet Impala Air Bag Clockspring includes a manufacturer's warranty. You can also get an easy return policy that keeps buying risk free. Fast delivery, get your car on the road quickly. It's simple to search, compare, and order. Stop guessing about quality or fit. Order today and save with parts that last.

The Air Bag Clockspring connects the Airbag module of the car; it is a part of the Supplemental Restraint System (SRS) to establish good electrical contacts with the electrical system of the Chevrolet Impala car. This connection is very important in the deployment of the airbags in case of an accident, thus increasing passengers' safety. High quality and long lasting, Air Bag Clockspring is made with, a combination of plastic and metal through out thus making it capable of handling the daily usage with maximum efficiency. Due to adaptability of the model in this list as spares for different generations of Chevrolet Impala and compatibility with different automobile brands. Besides, the Air Bag Clockspring particularly contributes to the functionality of the Impala's safety features, which in turn determines its efficiency. Over in the Air Bag Clockspring, they offers special features that distinguishes the product in the market, like the design that is in such a way that the movement of the steering wheel will not affect that of the airbag. This Air Bag Clockspring part is also in line of dependable performance thus enabling the Impala car to maintain it safety record and reliability in ways that suit the driver and the passenger. Safety and reliability can definitely be considered as the leading features of the Air Bag Clockspring, which proves the company's focus on the production of high-quality cars and parts.

Chevrolet Impala Air Bag Clockspring Parts and Q&A

Clockspring
19258035
Q: How to Remove and Replace the Air Bag Clockspring Assembly on Chevrolet Impala?
A:
To replace and remove the air bag clock spring assembly / spiral cable, turn off the sir system. With the vehicle wheels straight ahead, use vehicle's steering column anti-rotation pin (J42640), steering column lock, or strap to prevent its spinning which will prevent damage and possible sir system malfunction. Make sure that the Steering Wheel does not open before disconnecting the steering column, intermediate shaft(s), and steering gear. After isolating these components, do not twist the Steering Wheel or shift the front tires and wheels in order to avoid the possibility of the sir coil assembly going off-center. Ensure the wheels are straight ahead and j 42640 is installed or the ignition switch is in the lock position. Pull the Steering Wheel off the shaft on vehicles with a tilt steering column, pull the tilt lever straight out, then take out the 2 torx(R) head screws holding the lower trim cover, and then the two torx(R) head screws on the upper trim cover. Pull off the wire harness straps from the Steering Wheel column wire harness as well as the retaining ring so as to remove off the sir coil from the Steering Shaft. In case of replacing, throw away the old sir coil. For installation, make sure that the new sir coil assembly is centered, and never take out the centering tab before installation is over. If recycling the same coil, it must be centralized. Set the sir coil assembly parallel to the horn tower on the turn signal cancel cam assembly, slide the sir coil onto the Steering Shaft assembly and the retaining ring firmly seated into the groove on the Steering Shaft assembly. The centering tab must be removed and thrown out from the new sir coil. Install the upper trim cover using 2 torx (r) head screws and tighten to 1.5-nm (13 lb in), and the lower trim cover with two torx (r)'s head screws and ensure the tab on the lower trim cover clicks into the upper trim cover before tightening the screws. When using a tilt column, position the tilt lever handle in the steering column and slide it till it locks into position. Finally, mount the Steering Wheel on the Steering Shaft and activate the sir system.