Other Name: Switch, Turn Signal Lamp; Multi Purpose Switch; Signal Switch
Replaces: 20825752
Fits the following Cadillac Models:
SRX | 2010-2012 | Base, Luxury, Performance, Premium | 6 Cyl 2.8 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX
| Page 1 of 4 |Next >
1-20 of 79 Results
Cadillac Turn Signal Switch
Choose OEM Turn Signal Switch, you're making the optimal decision for superior quality and perfect performance. You can feel confident because each component goes through stringent quality checks. Every part is carefully built to comply with Cadillac's factory specifications. You'll enjoy a smooth, worry-free installation that fits just right. At ChevyPartsDeal.com, you'll find it easy to get top-quality OEM Cadillac Turn Signal Switch. You can shop at highly competitive prices and protect your budget. All our genuine Cadillac parts include a dependable manufacturer's warranty. You'll also appreciate our straightforward return policy and swift delivery services for extra convenience.
Q: How to replace the multifunction turn signal switch on Cadillac CTS?
A:
Start the multifunction Turn Signal Switch work by disabling the sir system through proper steps. Open the top and bottom trim before moving the Steering Column to its center position. Take off the assembly connectors from the turn signal and multifunction switch assembly before removing its 2 pan head tapping screws. Uninstall the complete turn signal and multifunction switch setup. To install the new part position the electrical contact pad correctly on the cancel cam and secure it with both screws while tightening the top column screw to 3 nm (27 inch lbs.) and tightening the front screw to 7 nm (62 inch lbs.). Rejoin all connectors to the switch section before putting back the trim parts and enabling steering input button (SIR).
Q: How to replace the Turn Signal Switch and multifunction switch on Cadillac Escalade?
A:
Before starting to replace the turn signal and multifunction switch you need to disable SIR system functions and take correct safety measures. Isolate the wire harness strap from its mountings by taking off the upper and lower trim pieces. Keep track of where the connector lies within its protective sleeve to help with reinstallation. Pull both connectors out from the bulkhead connection while removing their connection to the SIR system coil. Use your fingers to take out the turn signal and multifunction switch assembly which connects to the steering column goal assembly. Install the turn signal and multifunction switch assembly on top of the steering column tilt head assembly with 2 pan head screws. Tighten side screw to 7 N.m (62 lb in) and top screw to 3 N.m (30 lb in). Push both connectors into the bulkhead module and link the assembly connector to the SIR coil. Install the wire harness assembly back into its position at the wire harness strap. Make sure to place the abrasion sleeve correctly between the ignition lock wires and their connector exiting through the center area. Reinstall top and bottom trim parts while making the SIR system operational once more.