To service the cruise control module you must first remove the bolts of the upper fender brace assembly, and you then pull apart the upper tender brace assembly. Unplug the electric connector from the cruise control module and remove the module nuts from the cowl. Next, remove the cruise control cable from the device by using the suitable procedure for V8 or V6 replacement. After removing the cruise control module from the vehicle, install it back into the vehicle and connect the cruise control cable and end it using the relevant replacement procedure. Install the nuts to hold the cruise control module to cowl, and tighten to 9N.m or 80 lb in and reconnect the electrical connector at the cruise control module. Lastly, re-install the brace and bolt it tightly to 9 N.m (8 lb ft).