You should then remove the Clutch Cable adjustment nut from the end of the Clutch Cable and separate the cable from the lever at the clutch release lever. Next, it's time to remove the Clutch Cable bracket; it is advisable to remove two Clutch Cable grommet bolts from the bulkhead. Remove the Clutch Cable clevis from the clutch pedal lever and draw the Clutch Cable through the bulkhead from the engine compartment side. Check the Clutch Cable for frayed ends, kinks, and excessive wear and damage. For installing, smear the Clutch Cable clevis with lithium grease gm p/n 1051344 then run the Clutch Cable through the bulkhead from the engine compartment side after that bevel the to the clevis to the clutch pedal lever. Mount the 2 Clutch Cable grommet bolts to the bulkhead and tighten to 6 nm (53 inch lbs.). Afterwards, install the Clutch Cable through the Clutch Cable bracket then through clutch release lever and lock it down using the Clutch Cable adjustment nut . Adjust the free travel of the foot clutch pedal by loosening or tightening the Clutch Cable adjustment nut as required to measure the free travel of the clutch release lever within the 15 to 20mm (0.6 - 0.8 inch).