The first procedure to replace the right side parking brake rear cable on jf3, jf7, jg4 vehicles consists of releasing the park brake followed by disabling the park brake cable automatic adjuster. The vehicle needs to be elevated while you disconnect the right park brake cable from the intermediate cable equalizer bar. Rotating the locking tabs forward allows the right park brake cable to leave the frame bracket successfully while advancing the cable conduit toward the back. The procedure starts with detaching the park brake cable from the rear axle housing cover clip while removing the clip bolt before removing the cable from its guides. First you should take off the
Brake Shoes before detaching the park brake cable from the backing plate using the j 37043 tool to take the entirety of the component off the vehicle. Begin the installation process with the new park brake cable through which you should follow installation of brake shoes before ensuring proper engagement of cable conduit locking tabs within the rear axle bracket. Secure the park brake cable clip bolt at 22 nm torque value (16 lb ft). The park brake cable needs to be connected to the rear axle housing cover clip but the installation requires guiding the cable through its proper routes until right rear park brake cable is installed at the intermediate cable equalizer bar. Embed the park brake cable conduit into the frame bracket while making sure the locking tabs fulfill their full functionality. After enabling the automatic adjuster for the park brake cable let the brake need adjustment if required.