OEM Cadillac SRX Automatic Transmission Filter

Cadillac SRX Automatic Transmission Filter Parts and Q&A

• Filter
  24236931
  Q: What Tools Are Required to Service and Repair the Automatic Transmission Filter for the 5L40-E/5L50-E on Cadillac SRX?

  A:

  The required set of tools for servicing and repairing the automatic transmission fluid and filter of the 5l40-e/5l50-e includes slide hammer adapter (J 6125-1B), universal seal remover (J 23129), and transjel lubricant (J 36850). Start by lifting the vehicle and using a suitable drain tray positioned beneath the transmission fluid pan. You should loosen the fluid pan bolts that are located on the three sides of the fluid pan. Additionally, you can use a rubber mallet to lightly tap the pan if you want to loosen the gasket seal. During the fluid drain you should check for color changes and contaminates in the fluid. Before removing the fluid pan bolts you need to remove the fluid pan along with its gasket . The magnet along with the pan and bolts and gasket require inspections for possible damage or wear. Detach the transmission fluid filter by using a long screwdriver to extract the fluid filter neck from its seals followed by removal of the two fluid filter seals using the universal seal remover (J 23129) together with the slide hammer adapter (J 6125-1B). Two new fluid filter seals should be placed onto the transmission fluid filter neck but first coat them with transjel lubricant j 36850 or petroleum jelly before installation. When installing the transmission fluid filter then do it in the case while performing this step with the fluid pan and its gasket because fluid pan gaskets are reusable only in the absence of damage to their sealing surfaces. The fluid pan bolts need installation while torque should measure 11 n.m (97 lb in). Measure the transmission and fill it to specifications before lowering the vehicle to check for gasket leaks.
• Filter
  96042545
  Q: How to Replace the Automatic Transmission Filter and Fluid on Cadillac SRX?

  A:

  Proceeding with automatic transmission fluid and filter replacement requires slide hammer adapter (J 6125-1B), universal seal remover (J 23129), and transjel lubricant (J 36850) as tools. You need to support the vehicle while lifting it until you position a suitable drain pan below the transmission fluid Drain Plug. The Drain Plug goes first with its removal and subsequent discoloration check of the drained fluid. Install a Drain Plug onto the opening and torque it to 20 nm (15 ft.lbs.) using an appropriate tool. Use a rubber mallet to tap lightly on the fluid pan when needed before removing the three pan bolts. Before cleaning proceed with inspecting the magnet as well as transmission pan bolts and gasket for degradation and wear while cleaning both the pan and gasket . The fluid filter extraction requires a long screwdriver while you need universal seal remover (J 23129) with slide hammer adapter (J 6125-1B) to remove the two fluid filter seals. The two new fluid filter seals should be placed onto the filter neck after applying a small amount of transjel lubricant (J 36850) or petroleum jelly for improved installation. Place the transmission fluid filter inside the case. At the same time, you can install the fluid pan along with its gasket if the gasket is still usable. Use a torque wrench to fasten the fluid pan bolts to 11 nm (97 inch lbs.) and then fill the transmission to the right level and lower the vehicle for inspection of Oil Pan Gasket leaks.