Open the parking brake, lift the vehicle and hold it up with safety stands to proceed with the repairs. Remove the propeller shaft and after that, take out the nut and washer on a manual transmission or the bolt and washer on an automatic transmission. First, disconnect the drum and yoke assembly, then take off the bolts and washers and finally remove the drum from the yoke. During installation, join the drum to the yoke and make sure to tighten the bolts and washers using 37 nm (27 ft. Lbs.) of force. After that, set the drum and yoke in place and install the washer and nut (for manual) or the washer and bolt (for automatic) and secure them with the torque recommended. The last thing to do is fit the propeller shaft and bring the boat back down on the ground.