OEM 2007 GMC Envoy Door Check

2007 GMC Envoy Door Check Parts and Q&A

• Q: How to replace the door check link on 2007 GMC Envoy?

  A: Begin the door check replacement process by first removing both the door trim panel and front part of the water deflector which will provide access to the door access hole. The first step is to remove the front lower window run channel retaining bolt before proceeding with removal of the two bolts that connect the check to the pillar. Users should start by taking off the rubber dust boot from the check to reach door retaining nuts before removing the two check retaining nuts from the door to extract the check assembly through the door access hole. Put the check assembly through the door access hole with the forward-facing position arrow in mind. Fasten the two check retaining nuts on the door at 7 N.m (62 lb in). Secure the rubber dust boot onto the check before putting in the 2 bolts which attach the check to its pillar and tighten these to 15 N.m (11 lb ft). The installation procedure concludes with front lower window run channel reinstallation while fully seating the water deflector then attaching the door trim panel.