OEM 2007 Chevrolet HHR Alternator

2007 Chevrolet HHR Alternator Parts and Q&A

• Q: How to Perform an Alternator Replacement on 2007 Chevrolet HHR?

  A: First disconnect the negative terminal and then remove the ventilation module and Drive Belt respectively. The technician should lower the vehicle and remove the generator terminal nut while also removing the engine harness terminal from the generator. After removing the generator upper bolts you should raise and support the vehicle. First remove the generator lower bolt and disconnect the electrical connector only after cutting and repositioning the coolant heater cords if your vehicle has this component. The installation begins with generator positioning then executing generator electrical connector connection. Secure the coolant heater cord by using new tie straps when possible. Lower your vehicle then insert the generator upper bolts until they become snug before securing all generator bolts to 22 n.m (16 lb ft). Screw the engine harness terminal to the generator before tightening the generator terminal nut to 20 n.m (15 lb ft). When complete you must install the Drive Belt together with the air cleaner assembly before reattaching the negative Battery Cable.