OEM 2007 Chevrolet Corvette ABS Control Module

2007 Chevrolet Corvette ABS Control Module Parts and Q&A

• Q: How to replace the ABS Control Module on 2007 Chevrolet Corvette?

  A: The replacement of the ABS Control Module can begin when the ignition switch is switched off to avoid harming ABS Control Module components. The high-speed lan control modules need at least 2 minutes for deactivation following an ignition switch off. First disconnect the negative Battery Cable and then use a brush to eliminate dirt from the surroundings of the ABS Control Module and brake pressure modulator valve (BPMV). Elevate and stabilize the vehicle before unfastening the two bolts which anchor the bpmv bracket to the crossmember to reach both the ABS Control Module and connector. You should support the abs modulator assembly then disconnect the electrical connector from the brake fluid pressure sensor before releasing its cam to unplug the ABS Control Module electrical connector. Separate the ABS Control Module from the bpmv by removing its 4 ABS Control Module-to-bpmv retaining bolts in a precise manner. Before installation you must first clean the sealing surface of the bpmv with a shop cloth and denatured alcohol. Then attach the motor connector to the ABS Control Module and carefully align its electrical terminals while fixing the ABS Control Module to the bpmv. The 4 ABS Control Module-to-bpmv retaining bolts should be added in a crosswise pattern before tightening them to 5 n.m (44 lb in). Secure the lock tab of the ABS Control Module while you connect its electrical connector and do the same with the brake fluid pressure sensor electrical connector. The two bpmv bracket-to-crossmember mounting bolts should be installed next before lowering the vehicle and reconnecting the negative Battery Cable. Tighten the bolts to 27 n.m (20 lb ft). The installation of a new module requires necessary programming for the replacement component.