OEM 2007 Buick Rendezvous Crankshaft Position Sensor

2007 Buick Rendezvous Crankshaft Position Sensor Parts and Q&A

• Q: How to replace the Crankshaft Position Sensor on 2007 Buick Rendezvous?

  A: The first step when replacing the Crankshaft Position Sensor requires vehicle elevation followed by safety support. Move the Catalytic Converter out of the way before disconnecting the coolant heater cord from the coolant heater when present. You should start by disconnection of the engine harness electrical connector from the crankshaft position (CKP) sensor. Then remove the ckp sensor stud before you can take out the ckp sensor. Before placing a new sensor check the ckp sensor o-ring to see if it requires replacement due to wear or damage. Use clean engine oil to lubricate the sensor o-ring before installation of the ckp sensor. Standard replacement practice also applies here. Tighten the ckp sensor stud to 10 n.m (89 lb in). Connect the engine harness electrical connector back to the ckp sensor and reconnect the coolant heater cord to the heater unit (if heat is included) first lower the vehicle then position the Catalytic Converter and complete the ckp system variation learn procedure.