OEM 2006 Cadillac SRX ABS Control Module

2006 Cadillac SRX ABS Control Module Parts and Q&A

• Q: How to replace the ABS Control Module on 2006 Cadillac SRX?

  A: The first step to replace the abs control module (ABSCM) requires turning the ignition off because this prevents equipment damage. You should support the vehicle before removing the air deflector shield and the right front wheelhouse liner. The washer solvent container stays in place without removal but its bracket should be detached. Apply thorough cleaning of the abscm area because dirtying the abs components during disassembly endangers their operation. Use your fingers to push the connector retainer to unlock it. Then pull the connector tab forward to separate the abscm electrical connector which you should keep aside. Wash away the four abscm to brake pressure modulator valve (BPMV) screws and clean all abscm/bpmv surface areas. The repair of abscm is not possible so replace it when it fails by disconnecting the abscm component from the bpmv. Place the new abscm unit onto the bpmv with correct alignment of the internal pump motor connector. Then secure the installation by covering the bpmv seal surface. Embed the abscm to bpmv with new screws following a sequence of tightening from 1 to 4 until they reach 5 Nm (44 inch lbs.). Put the abscm electrical connector onto the abscm unit and push the connector tab to the back until it secures into position. The installation process includes putting back the washer solvent container bracket followed by the wheelhouse liner and air deflector shield. Then raise the vehicle. The scan tool will allow clearing of dtcs and performing an abs diagnostic system check.