OEM 2003 Chevrolet SSR Brake Pad

2003 Chevrolet SSR Brake Pad Parts and Q&A

• Q: How to replace the rear brake pads on 2003 Chevrolet SSR?

  A: Examine brake fluid level in brake master cylinder reservoir first; if fluid stands between full and minimum recommendations, do not empty it but drain existing fluid if the level reaches above the midway point. Place the vehicle on an elevated position to take off rear tire and wheel components. Push the brake caliper pistons into the housing by tightening a strong c-clamp on top of the caliper against the Brake Pad at the back. Gradually tighten the clamp until the caliper can move off the rotor before removing the clamp. Unbolt the top brake caliper mount and turn the rear brake caliper down before taking off both brakes pads along with their mounting clips from the brake bracket and removing the caliper retaining clip. Use non-lubricated filtered air to wipe the brake caliper mounting bracket clean after soaking it in denatured alcohol. Replace all Brake Pad retaining clips when installing new brake pads because old retaining clips are not suitable for use. Insert new brake pads onto the brake caliper mounting bracket using new Brake Pad retaining clips that are properly positioned within the brake caliper. Put the caliper-operating clip in place at its designated position afterward push the brake caliper up into its optimal position and fix the caliper's upper bolt using 31 nm tightening force. Put the wheel and tire back and let the vehicle down while adding fluid to the brake master cylinder if required. Slowly push the Brake Pedal firmly while allowing the brake pads to settle into place before finishing pad burnishing.