How to service the Power Door Lock Switch on 2002 Buick Rendezvous?

To get the door trim panel off to service Power Door Lock Switch, start by picking up the blades to press in the latches; this will allow you to release the lock. Unscrew the two clips that are at the top and bottom of the door lock switch using a small flat-edged tool and remove the connector for the electrical connector from the switch, and then the switch as well. For installation, place the door lock switch onto the trim panel and push until seated fully. Next, reinstall the electrical connector to the door lock switch, reassemble the door trim panel and finally test the lock switch to confirm proper operation.

OEM 2002 Buick Rendezvous Door Lock Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Door Lock Switch found

View related parts
2002 Buick Rendezvous Lock Switch, Driver Side Part Number: 10422426
Product Specifications
- Other Name: Switch, Door Electric And Vacuum Locks; Door Lock Switch
- Position: Driver Side
- Item Weight: 0.40 Pounds
- Item Dimensions: 2.7 x 2.2 x 1.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 10422426
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2002 Buick Rendezvous Submodels:
- CX, CX Plus, CXL, CXL Plus, Ultra | 6 Cyl 3.4 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L GAS

2002 Buick Rendezvous Door Lock Switch

With a comprehensive array of OEM 2002 Buick Rendezvous Door Lock Switch, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2002 Buick Rendezvous Door Lock Switch are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2002 Buick Rendezvous Door Lock Switch Parts and Q&A

Q: How to service the Power Door Lock Switch on 2002 Buick Rendezvous?
A: To get the door trim panel off to service Power Door Lock Switch, start by picking up the blades to press in the latches; this will allow you to release the lock. Unscrew the two clips that are at the top and bottom of the door lock switch using a small flat-edged tool and remove the connector for the electrical connector from the switch, and then the switch as well. For installation, place the door lock switch onto the trim panel and push until seated fully. Next, reinstall the electrical connector to the door lock switch, reassemble the door trim panel and finally test the lock switch to confirm proper operation.