OEM 2001 Buick Century Turn Signal Switch

2001 Buick Century Turn Signal Switch Parts and Q&A

• Q: How to replace the Turn Signal Switch on 2001 Buick Century?

  A: To replace the Turn Signal Switch start by putting the lever in the middle of off position then take off the negative Battery Cable. Shut off sir before uninstalling the Steering Wheel and panel cover pieces from steering column. Remove the wire harness straps attaching to the steering column then disconnect the Turn Signal Switch assembly connector from its connector on the sir coil assembly. Use a small tool to push out the turn signal, turn signal, and hazard switch assembly connectors from their slot at the steering column bulkhead. Then remove and take out the assembly from its position on the tilt head. A small flat-blade tool puts the electrical contact in place allowing you to position both cabin controls on the steering column. Keep the electrical contact resting evenly on top of the turn signal canceling cam during assembly. Use a torque wrench to fasten the screws to 7 nm (62 inch lbs.) before connecting the assembly connectors to the steering column bulkhead socket and from there back to the sir coil assembly connector. Snap the wire harness onto its hooks at the steering column then make sure the lever points straight ahead or to the off mark. Put back the steering trim parts and wheel. Complete the process by turning on sir functionality and reuniting the battery negative leads.