OEM Chevrolet Prizm Headlight Switch

Chevrolet Prizm Headlight Switch Parts and Q&A

• Multifunction Switch
  94857234
  Q: How to service and repair the headlight switch on Chevrolet Prizm?

  A:

  Service and repair of the headlamp switch starts with disabling the sir system. You can access the two lower trim cover screws which serve underneath the Steering Wheel by rotating the wheel without complete uninstallation. You should proceed to remove the Steering Column lower trim cover. Begin the procedure by unfastening both the Steering Column upper trim cover screw along with the upper trim cover itself. Examine the base for damages before deciding to replace the turn signal with the headlamp as well as windshield washer switch combined as a single unit. Detach the electrical connector of the turn signal/headlamp switch before removing the two screws that hold the turn signal/headlamp switch in place. Fasten the turn signal/headlamp switch onto the Steering Column by using the two screws for attachment. Begin by restarting the turn signal/headlamp switch electrical connection and afterward install and screw down the Steering Column upper trim cover. Secure the Steering Column lower trim cover with its three screws before sir system activation is possible.
• Headlamp Dimmer Switch
  94857235
  Q: How to replace the Headlight Switch on Chevrolet Prizm?

  A:

  Before switching out the headlamp switch you need to disable the sir system operation. The access to lower trim cover screws becomes reachable through Steering Wheel rotation without needing to remove the Steering Wheel. Starting from the lower trim cover screw and moving to the two lower trim cover screws that lie beneath the wheel you should remove all the screws to detach the steering column lower trim cover. Secondly detach the steering column upper trim cover screw followed by removing the upper trim cover. Base damage requires replacement of the turn signal together with the headlamp and windshield washer switch unit as a complete assembly. Begin by disconnecting the turn signal/headlamp switch electrical connector and afterwards remove the two screws then detach the turn signal/headlamp switch. To install the turn signal/headlamp switch place it on the steering column while using the two screws as a mounting mechanism. Attach the turn signal/headlamp switch electrical connector before you install the steering column upper trim cover along with its screw. Complete the installation by secure the three screws into the steering column lower trim cover after which the sir system can be enabled.