OEM Chevrolet Prizm Brake Line

Chevrolet Prizm Brake Line Parts and Q&A

• Flex Hose
  94856336
  Q: How to replace the rear brake line on Chevrolet Prizm?

  A:

  Before starting the rear brake hose replacement take all brake fluid from the master cylinder reservoir. Make the vehicle stable then lift it before taking out the rear tire and wheel parts. Clean the hose and its parts properly before disconnecting the brake hose from its joint points. You must pull the retaining clips first to extract the rear brake hose from your vehicle. Attach the new rear brake hose first through the retaining clips then join it to brake system components. Bleed the braking system then put back the wheel and tire at the rear before lowering the vehicle.
• Flex Hose
  94859868
  Q: How to replace the front brake line on Chevrolet Prizm?

  A:

  The brake hose front replacement process starts by drawing fluid from the master cylinder reservoir before raising and supporting the vehicle. Start by cleaning away dirt and undesirable objects from both the hose and fittings after removing the front tire and wheel assembly. Start by disconnecting the front brake hose from the front brake pipe while you remove the front brake hose retaining bracket along with its bolt and front brake hose from the front strut. The brake caliper procedure requires removal of the brake hose bolt along with the two seal washers and brake hose from the brake caliper. Install the brake caliper by using the brake hose bolt to fasten the brake caliper with the brake hose along with the two seal washers while tightening the bolt to 8 nm (17 inch lbs.). After fitting the front brake hose into position you must attach the front brake hose retaining bracket followed by the front brake hose retaining bracket bolt at the front strut while tightening the bolt to 15 nm (11 ft. Lbs.). Install the front brake hose to the front brake pipe then bleed the brake system before putting back the wheel assembly with front tire and bringing down the vehicle.