OEM Chevrolet Avalanche 1500 Sway Bar Link

Chevrolet Avalanche 1500 Sway Bar Link Parts and Q&A

• Stabilizer Link
  10385580
  Q: How to replace the rear Sway Bar Link on the 15/25 series on Chevrolet Avalanche 1500?

  A:

  Replacing the sway bar link on the rear suspension of the 15/25 series begins with vehicle lift and stabilization. Start by uninstalling the sway bar link nut and bolt from the frame bracket before removing the sway bar link nut from the ball stud then removing the sway bar link. Start by installing the sway bar link before you put on the sway bar link nut to the ball stud while verifying that the inner jam nut hits the bottom of the ball stud when you tighten it. Marina should place the sway bar link nut and bolt at the frame bracket. Screw the ball stud to sway bar nut until it reaches 65 N.m (48 lb ft) while the link to frame bracket nut requires 65 N.m (48 lb ft) torque before dropping the vehicle.
• Stabilizer Link
  15257472
  Q: How to replace the front sway bar link on Chevrolet Avalanche 1500?

  A:

  The stabilization process requires lifting up and supporting the motor vehicle as the first step. First remove the sway bar link nut from the link bolt and then take out both the sway bar link bolt and sway bar link insulators with their spacers. A thorough examination should be conducted to check for damage in all parts. The installation process starts by repositioning both sway bar link insulators and spacers. Before bolting the sway bar link to its place you must first clean away all original adhesive residues then apply threadlocker gm p/n 12345382 (canadian p/n 10953489) blue loctite # 242 between the threads of each bolt. Mount the sway bar link bolts as the next step before fastening the sway bar link nut to the link bolt with a torque of 10 N.m (89 lb in) while allowing 2-4 threads to appear beyond the nut. The sway bar stays safe when clamp load loss happens because the link bolt threads should stick out by 2 to 4 threading above the link nut following torque completion. End the procedure by taking out safety stands before lowering the vehicle.