Other Name: Sensor Assembly-Heated Oxygen (Position 2); Sensor, Computer Control Sensors
Position: Passenger Side
Replaces: 12570794
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2003-2005 Chevrolet Astro | Base, LS, LT | 6 Cyl 4.3 L GAS
Chevrolet Astro Oxygen Sensor
Want to cut long-term maintenance and repair costs? Choose OEM Oxygen Sensor. Those parts deliver top durability you can trust. On our site, you'll find a huge catalog of genuine Chevrolet Astro parts. Prices are unbeatable, so you can keep more in your pocket. Every OEM Chevrolet Astro Oxygen Sensor includes a manufacturer's warranty. You can also get an easy return policy that keeps buying risk free. Fast delivery, get your car on the road quickly. It's simple to search, compare, and order. Stop guessing about quality or fit. Order today and save with parts that last.
The Oxygen Sensor in automobiles particularly Chevrolet Astro is essentially used to check the residual unburned oxygen in the exhaust gas that is very useful to determine the mixture of air and fuel as well as generic emissions. It produces a voltage signal proportional to the concentration of oxygen, therefore the engine control computer is in a position to change the pulse width of the fuel injector. This back feedback system makes the engine to run in a "closed loop" improving the efficiency of the catalytic converter. Chevrolet Astro cars might have zirconium dioxide oxygen sensors, both narrow-band and wideband sensors are possible. Narrow-band sensors deliver repeatedly shifting rich/lean signals, while wide-band sensors supply a wider air-fuel mixture range signals. These sensors can, however, reduce in their effectiveness over time because of contaminant which causes excess emissions and less fuel economy. A Chevrolet Astro's Oxygen Sensor should be checked and serviced as often as possible for the vehicle to operate optimally.
Q: How to service the oxygen sensor on Chevrolet Astro?
A:
The service of the Oxygen Sensor begins with disconnecting the negative Battery Cable. The technician should lift the vehicle and handle the Oxygen Sensor properly while keeping the pigtail connector attached to both the heated Oxygen Sensor (HO2S) and the Oxygen Sensor (O2S). Operating the sensors relies on this connection. The j 39194 Oxygen Sensor wrench (J 39194) serves to detach the ho2s harness connector that exists in 1x4 or 2x2 formats. Operating below 48°c (120°F) requires caution when removing the ho2s since hard efforts may damage Exhaust Manifold or pipe threads. The j 39194 Oxygen Sensor wrench (J 39194) should be used to install the sensor after applying anti-seize compound gm p/n 5613695 on the threads if needed. Tighten the sensor to 42 n.m (31 lb ft). End the process by connecting the ho2s harness connector while lowering the vehicle then reattach the negative Battery Cable.
Q: How to replace the Heated Oxygen Sensor (HO2S) Bank 1 Sensor 2 on Chevrolet Astro?
A:
The Heated Oxygen Sensor (HO2S) Bank 1 Sensor 2 replacement process begins with vehicle elevation and removal of the HO2S connector. You must remove the HO2S by using the Oxygen Sensor Wrench (J 39194-B). Workers should apply anti-seize compound GM P/N 5613695 to the threads before reinstallation of the sensor. Use the Oxygen Sensor Wrench (J 39194-B) to install the HO2S then apply torque to 42 N.m (31 lb ft). Connect the HO2S harness connector and put away the vehicle.