OEM Cadillac DeVille Throttle Cable

Cadillac DeVille Throttle Cable Parts and Q&A

• Cable
  25731924
  Q: How to replace the throttle cable on Cadillac DeVille?

  A:

  Start cable replacement by disconnecting the Throttle Cable from its position on the accelerator controls bracket and throttle body lever. Proceed to disconnect it at the retainer on the bulkhead. Successively remove the left closeout insulator panel before using pliers to compress the Throttle Cable cover tangs for bulkhead passage. The next installation step requires separation of the Throttle Cable from the brake pedal components at its accelerator controls pedal connection point. When installing the Throttle Cable it must be connected to the throttle body lever while carefully directing it through the grove in the lever until it is properly seated. Connect the Throttle Cable to the accelerator controls cable bracket followed by routing it above the Brake Master Cylinder through the bulkhead until it reaches the retainer. Use the Throttle Cable for the accelerator at the accelerator controls pedal while performing checks for total throttle movement ranges and inspecting open and closed throttle positions independently of each other before mounting the left closeout insulator panel.
• Throttle Cable
  25666747
  Q: How to Service and Repair the Throttle Cable on Cadillac DeVille?

  A:

  To service and repair the Throttle Cable; start by removing the Throttle Cable from the accelerator controls bracket to the throttle body lever. Next come off the cable at the retainer on the bulkhead and pull the left closeout insulator panel. Compress the cover annuls of the Throttle Cable and at the bulkhead, next disconnect it at the accelerator controls pedal and take the cable away. For installation part flexible parts, it should not be routed closer than 50mm (2pt.set) from moving parts such that they will not interfere from one another and are damaged. Mount the Throttle Cable at throttle body lever and accelerator controls cable bracket such that it runs through the groove in throttle body lever and it is firmly seated. The Throttle Cable should run through the groove in the throttle body lever. Install the Throttle Cable so that it is firmly seated the accelerator controls cable bracket at throttle body lever. The Throttle Cable, route it over the Brake Master Cylinder and through the bulkhead, and tie it to the retainer on the bulkhead. Finally, install the Throttle Cable at the accelerator controls pedal, confirming the full throttle open/closed positions, by operating the pedal, and checking there is no bind between full closed & wide open throttle. End up by reinstalling the left closeout insulator panel.