To replace the headlamp assembly or headlamp bulb or cornering, sidemarker, park, and turn signal bulb, start by opening the hood. Tighten the lens-to-socket attachment by placing light pressure onto the headlamp lens as the retainers are removed. Next, pop up retainers off the headlamp with a pop and take off retainers. Next, unhook the headmounts from the slots on the upper fascia support and the fender reinforcement, and separated the head lamp electrical connector from the head lamp before taking it out. Trim the rubber access covers off from the rear of the headlamp bulb/sockets requiring replacement and rotate the headlamp bulb/socket counterclockwise to remove it, while maintaining a watch for the Halogen Bulb. Caution. Afternoon, pull the headlamp bulb/socket from the headlamp and undo the electrical connector. For installation, attach electrical connector to the headlamp bulb/socket then push the headlamp bulb/socket into the headlamp and twist clockwise for seating. Install the rubber access covers, connect the electrical connector to the headlamp, and install the headlamp mounting tabs into the slots. Use a light pressure on the head lamp lens during installation of the retainers while aligning them over the mounting tabs and a firm press down for the fully seating in position. Check the headlamp for free movement and inspect the headlamp aim if a new lamp or if some service or repair has potentially affected the mounting brackets. Finally, close the hood.