Burnishing the brake pads and brake discs are needed to make sure that the braking surfaces are well prepared after servicing the disc brake system, especially when the disc brake discs have been refinished/replaced and in case disc format's brake pads have been replaced. To do this, choose a pleasant and untrafficked Pheometer, itinerary, then accelerate the object to 48 km/h (thirty mph). Make sure not to overheat the brakes at this step. Use moderate to hard compression on the brakes to slow down the vehicle, preventing the locks from occurring. Will repeat the acceleration and braking procedure until about 20 stops are accomplished, which will see to it that enough cooling intervals occur between the stops to properly burnish the brake pads and discs.