OEM 2010 Buick Lucerne Antenna Cable

2010 Buick Lucerne Antenna Cable Parts and Q&A

• Q: How to replace the digital radio antenna cable on 2010 Buick Lucerne?

  A: The replacement of digital radio Antenna Cable requires you to first eliminate the upper rear quarter trim panel and rear assist handles while keeping the headliner safe during this work. First disconnect the Antenna Cable from its clips and then disconnect the Antenna Cable connection from above the am/fm Antenna module before removing the foam tape from this connection point. Proceed to separate the radio Antenna connectors before you fix a wire or string to the Antenna Cable terminus. Drill out the left rear compartment trim panel before you disconnect the Antenna Cable interface that connects to the digital receiver. Go through the rear shelf to access the Antenna Cable clips and harness after removing the wire or string from the cable before extracting it from your car. Tie a wire or string to the Antenna Cable before guiding it through the rear shelf into the front section while removing the wire. Secure the Antenna Cable by installing it onto the digital receiver while holding the clips in place on the rear compartment. After reinstalling the left rear compartment trim panel you should connect Antenna connectors to the digital radio Antenna before applying foam tape around the connector. Attach the Antenna Cable above the am/fm Antenna module and fasten it to locating clips found at the roof and third pillar. Install the upper rear quarter trim panel afterwards while aligning the headliner to the roof panel and reinstalling the rear assist handles.