OEM 2010 Buick Enclave Power Steering Pump

2010 Buick Enclave Power Steering Pump Parts and Q&A

• Q: How to replace the power steering pump on 2010 Buick Enclave?

  A: You should start the Power Steering Pump replacement procedure by taking off the fuel injector sight shield. The remote power steering fluid reservoir requires maximum fluid drainage and the vehicle needs drain pans positioned beneath. The replacement procedure begins by taking off the Drive Belt then moving to the steering gear heat shield after that follows the right side Catalytic Converter removal. Safely disconnect the power steering fluid reservoir outlet hose together with the power steering gear inlet hose from the Power Steering Pump. The mechanics need to remove the Power Steering Pump bolts while disassembling the Power Steering Pump and they should carry any needed components through the vehicle's removal process. The installation of the Power Steering Pump requires its placement back into the vehicle before securing Power Steering Pump bolts with a torque of 50 nm (37 lb ft). The power steering gear inlet hose fitting should be joined to the Power Steering Pump following a 34 nm (25 lb ft) torque setting and the reservoir outlet hose must be installed to the pump. Excessive fluid should be wiped off before reinstalling the right side Catalytic Converter alongside the steering gear heat shield and Drive Belt. Complete the power steering system filling process along with bleeding before replacing the fuel injector sight shield.