OEM Buick Enclave Power Steering Pump

Buick Enclave Power Steering Pump Parts and Q&A

• Power Steering Pump
  85112727
  Q: How to Service and Repair a Power Steering Pump on Buick Enclave?

  A:

  The Power Steering Pump replacement process begins by taking away the fuel injector sight shield followed by a fluid drainage of remote power steering fluid into drain pans placed underneath the vehicle. The Drive Belt should be removed then the steering gear heat shield after which the right-side Catalytic Converter needs removal. Begin by disconnecting the power steering fluid reservoir outlet hose and the power steering gear inlet hose from the Power Steering Pump. Subsequently remove and take out the Power Steering Pump from the vehicle while transferring important parts. Reinstall the Power Steering Pump into its place in the vehicle while tightening Power Steering Pump bolts to 50 n.m (37 lb ft). After fitting the power steering gear inlet hose to the Power Steering Pump perform a tightening procedure at 27 n.m (20 lb ft). Then install the power steering fluid reservoir outlet hose. To proceed with the right side Catalytic Converter and steering gear heat shield installation a solution of mild detergent should be used to clean any extra fluid before removing drain pans then placing these components back into their proper positions. End the procedure by installing the Drive Belt while completing power steering system fillup and bleeding then reinstalling the fuel injector sight shield.