How to replace the Radiator Grille Emblem/Nameplate on 2009 Chevrolet Trailblazer?

To replace the Radiator Grille Emblem/Nameplate on the TrailBlazer LT first use tape and protect the mounting surface and make alignment marks for installation. Use a heat gun to heat the emblem/nameplate in a circular motion for approximately 30 seconds to enable smooth removal off the hood. Care should be taken with fasteners so as not to damage the vehicles. Remove the emblem/nameplate from the panel surface by using a plastic, flat bladed tool. To remove adhesives, use a 3M™ (scotch brite) molding adhesive remover disk™, (3M TM-P/N-07501), body panels, or you could use lint-free rag and Varnish Makers and Painters (VMP) naptha or a 50/50 mix of Iso propyl alcohol and water for plastic panels. When replacing the newly purchased emblem/name plate, make sure it is installed in a dust-free environment to avoid adhesion problems. Clean the installation area with a lint-free cloth using the same cleaning solution on it and dry it well. Mark the place with tape, warm the area where mounting will be to 27-41°C (80-105°F), and make sure the emblem/nameplate is 29-32°C (85-90°F). Peel off the protective liner from the back of the emblem/nameplate, position it over the marked spot, and hold it there firmly till a uniform bond is made. Finally, lower the protective tape from mounting surface.

OEM 2009 Chevrolet Trailblazer Emblem

Badge

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

8 Emblems found

View related parts
2009 Chevrolet Trailblazer Emblem, Front Part Number: 20831223
$67.77 MSRP: $100.87
You Save: $33.10 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Emblem, Radiator Grille And Front End Ornamentation; Emblem, Bumper/Fascia
- Position: Front
- Replaces: 15228866, 15102863, 15791403
- Item Weight: 0.50 Pounds
- Item Dimensions: 9.0 x 3.7 x 0.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 20831223
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2009 Chevrolet Trailblazer Submodels:
- LT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2009 Chevrolet Trailblazer Nameplate, Driver Side Part Number: 15287410
$52.07 MSRP: $77.50
You Save: $25.43 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Emblem Assembly-Lift Gate (Trailblazer Left); Emblem, End Gate And Rear Door Decoration
- Position: Driver Side
- Replaces: 15216799
- Item Weight: 0.40 Pounds
- Item Dimensions: 3.9 x 12.9 x 0.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 15287410
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2009 Chevrolet Trailblazer Submodels:
- LT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2009 Chevrolet Trailblazer Emblem, Front Part Number: 15211285
$23.95 MSRP: $35.64
You Save: $11.69 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Emblem, Front Side Door; Nameplate; Plate Assembly, Cab And Load Carrier Outer Side Decoration; Plate Assembly, Front Side Door
- Position: Front
- Item Weight: 0.30 Pounds
- Item Dimensions: 6.9 x 2.7 x 0.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 15211285
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2009 Chevrolet Trailblazer Submodels:
- SS | 8 Cyl 6.0 L GAS
View related parts
2009 Chevrolet Trailblazer Nameplate, Rear Part Number: 10336980
$24.53 MSRP: $36.51
You Save: $11.98 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Plate, Rear End Panel And Tailgate; Plate, End Gate and Rear Door Decoration; Emblem, Rear End Panel; Plate Assembly, Front Side Door.
- Position: Rear
- Item Weight: 0.30 Pounds
- Item Dimensions: 5.5 x 2.1 x 0.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 10336980
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2009 Chevrolet Trailblazer Submodels:
- SS | 8 Cyl 6.0 L GAS
View related parts
2009 Chevrolet Trailblazer Emblem Part Number: 84689784
$11.42 MSRP: $17.00
You Save: $5.58 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Emblem, Front Side Door; Decal; Nameplate; Emblem, Cab, Load Carrier, Rear End, Door, Quarter Panel, Fender, Rocker Panel, Side Step.
- Replaces: 15223483, 15223484
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 84689784
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following 2009 Chevrolet Trailblazer Submodels:
- Base, LS, LT, SS | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
2009 Chevrolet Trailblazer Emblem, Front Part Number: 10357171
$117.32 MSRP: $175.40
You Save: $58.08 (34%)
Product Specifications
- Other Name: Emblem, Radiator Grille And Front End Ornamentation; Emblem, Front Bumper
- Position: Front
- Replaces: 15199885
- Item Weight: 1.30 Pounds
- Item Dimensions: 8.9 x 3.6 x 3.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 10357171
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2009 Chevrolet Trailblazer Submodels:
- Base, LS, LT, SS | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
2009 Chevrolet Trailblazer Emblem, Rear Part Number: 20830823
Product Specifications
- Other Name: Decal, End Gate And Rear Door Decoration; Decal; Emblem, End Gate And Rear Door Decoration
- Position: Rear
- Replaces: 15056111, 89044570
- Item Weight: 0.40 Pounds
- Item Dimensions: 5.3 x 2.4 x 0.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 20830823
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2009 Chevrolet Trailblazer Submodels:
- Base, LS, LT, SS | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
2009 Chevrolet Trailblazer Nameplate, Rear Part Number: 15287415
Product Specifications
- Other Name: Plate, Rear End Panel And Tailgate; Plate, End Gate And Rear Door Decoration
- Position: Rear
- Replaces: 15118324
- Item Weight: 0.30 Pounds
- Item Dimensions: 13.2 x 1.6 x 0.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 15287415
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2009 Chevrolet Trailblazer Submodels:
- Base, LS, LT, SS | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS

2009 Chevrolet Trailblazer Emblem

With a comprehensive array of OEM 2009 Chevrolet Trailblazer Emblem, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2009 Chevrolet Trailblazer Emblem are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2009 Chevrolet Trailblazer Emblem Parts and Q&A

Q: How to replace the Radiator Grille Emblem/Nameplate on 2009 Chevrolet Trailblazer?
A: To replace the Radiator Grille Emblem/Nameplate on the TrailBlazer LT first use tape and protect the mounting surface and make alignment marks for installation. Use a heat gun to heat the emblem/nameplate in a circular motion for approximately 30 seconds to enable smooth removal off the hood. Care should be taken with fasteners so as not to damage the vehicles. Remove the emblem/nameplate from the panel surface by using a plastic, flat bladed tool. To remove adhesives, use a 3M™ (scotch brite) molding adhesive remover disk™, (3M TM-P/N-07501), body panels, or you could use lint-free rag and Varnish Makers and Painters (VMP) naptha or a 50/50 mix of Iso propyl alcohol and water for plastic panels. When replacing the newly purchased emblem/name plate, make sure it is installed in a dust-free environment to avoid adhesion problems. Clean the installation area with a lint-free cloth using the same cleaning solution on it and dry it well. Mark the place with tape, warm the area where mounting will be to 27-41°C (80-105°F), and make sure the emblem/nameplate is 29-32°C (85-90°F). Peel off the protective liner from the back of the emblem/nameplate, position it over the marked spot, and hold it there firmly till a uniform bond is made. Finally, lower the protective tape from mounting surface.