How to replace the rear outer CV Boot and CV Joint on 2009 Cadillac SRX?

Question

Accepted Answer

Begin rear wheel drive shaft outer joint and boot replacement by taking out the wheel drive shaft from the vehicle. A shop towel protects the Axle Shaft while the wheel drive shaft rests horizontally inside a bench vise. First remove large and small seal retaining clamps using a side cutter before sliding the outer joint seal away from the joint face after breaking it from the outer race at its large diameter end. The outer joint's removal from the Axle Shaft begins by aligning a brass drift on the inner race while maintaining the inner joint housing horizontally for striking with a hammer until the Axle Shaft retaining clip compresses. Lowering the retaining ring allows disposal of it before getting the seal off the Axle Shaft. Before beginning installation place the vertical outer race inside a bench vise while securing it with a shop towel wrapped around its splined shaft. Use a brass drift and hammer to press the first wheel drive shaft joint's inner cage balls out before fully removing all balls while maintaining a flat orientation of the cage and inner race. Using solvent to clean all parts until they become dry you must check for damage and wear. Assemble the large-radius corners of the cage up then insert the inner race horizontally making sure the splined groove faces upward. Place the outer race into the bench vise vertically as you wrap a shop towel around the joint outer race splined shaft. Then align the inner race ball tracks with the cage windows. Position the cage and inner race in alignment with the outer race while placing the inner race ring opening bottom-up. Proceed to install balls one-by-one by inspecting for proper ball-to-inner race ball track contact. The brush operation involves placing up to 60 percent of service kit grease into the outer joint and applying it evenly across ball tracks and balls and cage and inner race. Lay a shop towel around the Axle Shaft before installing the wheel drive shaft horizontally into a bench vise. The installation process requires new small seal retaining clamps and seals that need to be fitted onto the Axle Shaft followed by new retaining rings. Drill inner race splines through the Axle Shaft splines as you compress the Axle Shaft ring spacer and drive the inner joint onto the shaft with a wood block and hammer until it reaches full engagement. Use the j 42572 to crimp the small seal retaining clamp into the seal boot groove after filling the remaining grease. Maintain a 1 mm (0.039 in) gap from the base of the omega ohm shape. Crimp the large seal retaining clamp to the seal by using the j 42572 tool which should maintain a 1 mm gap while making sure the seal stays undamaged. Check the wheel drive shaft's outer joint operation by rotating it vertically several times before reinstallment.

OEM 2009 Cadillac SRX CV Boot

6 CV Boots found

2009 Cadillac SRX Outer CV Joint Boot Part Number: 88957226

2009 Cadillac SRX Inner CV Joint Boot Part Number: 88957225

2009 Cadillac SRX Outer Boot Part Number: 88957228

2009 Cadillac SRX Outer Boot Part Number: 88957230

2009 Cadillac SRX Inner Boot Part Number: 88957227

2009 Cadillac SRX Inner Boot Part Number: 88957229

2009 Cadillac SRX CV Boot

2009 Cadillac SRX CV Boot Parts and Q&A

Related 2009 Cadillac SRX Parts

Alternate Year Models