OEM 2008 Chevrolet Uplander Air Suspension Compressor

2008 Chevrolet Uplander Air Suspension Compressor Parts and Q&A

• Q: How to replace the Air Suspension Compressor on 2008 Chevrolet Uplander?

  A: In order to change the Air Suspension Compressor, first, lift and prop up the vehicle. To unhinge the Air Suspension Compressor filter, compress the sides of it while it is still on the under body rail, then use the bolt and nuts that hold compressor bracket to take it out, and your compressor will hang on the bracket hook. Next, separate the air line from the air dryer and cut the Air Suspension Compressor electric connector. Feel the Air Suspension Compressor by rotating it and the bracket 90 degrees to release the bracket hook from the car and then take the Air Suspension Compressor and the bracket off. Remove the Air Suspension Compressor dryer, the Air Suspension Compressor relay from the bracket, Air Suspension Compressor bolt, and Air Suspension Compressor out of the bracket. Reinstall by connecting the Air Suspension Compressor filter hose on two places, but you must follow fastener notices. Fasten the Air Suspension Compressor to the bracket, with the bolt tightness at 50 n.m (37 lb ft), and fix the Air Suspension Compressor bolts/screws by fastening them with a tightness of 4 n.m (35 lb in). Secure the Air Suspension Compressor shield and tighten the bolts to 3 n.m (27 lb in), and then the Air Suspension Compressor relay. Reattach the Air Suspension Compressor dryer, then fasten the Air Suspension Compressor bracket to the underbody rail, rotate it by 90 degrees to allow the compressor to hang on the bracket hook. Connect the elec. Connector install the air line to the air dryer and bracket nuts tight to 10 n.m (89 lb in) and bracket bolt/screw tight to 50 n.m (37 lb ft). Lastly, fix the Air Suspension Compressor filter to the underbody rail and lower your vehicle.