OEM 2008 Cadillac XLR A/C Condenser

2008 Cadillac XLR A/C Condenser Parts and Q&A

• Q: How to replace the A/C Condenser in a system on 2008 Cadillac XLR?

  A: Begin by using a halogen leak detector j 39400-a to check for leaks on the component fittings. Start your work by extracting refrigerant from the a/c system. The upper radiator support needs to be taken off next. Start by removing the fitting bolt to disconnect the a/c compressor hose assembly from the A/C Condenser fitting before immediately sealing the open a/c components with caps or tape to prevent contamination. Next raise the vehicle and proceed to take off the front evaporator inlet line bolt from the A/C Condenser before disconnecting the line so discard the seal washer and use caps or tape to seal the line. Use an air hammer to remove one lh and one rh radiator baffle upper retainer pin then push the baffle forward for more clearance. Lower the condenser along the radiator to free its tabs from the slots before taking it out of the vehicle. To install a new condenser add pag oil as specified then lower the unit into the vehicle for secure tab insertion into radiator slots before reinstallation. Connect the front evaporator inlet line to the A/C Condenser by installing a new washer and tighten the bolt to 16 n.m (12 lb ft). Connect the hose assembly to the A/C Condenser using a new seal washer followed by tight bolt installation at 16 n.m (12 lb ft). To complete this procedure you should reinstall the upper radiator support and then evacuate and recharge the a/c system following your test with the halogen leak detector (J 39400-A).