How to replace the engine oil and oil filter on 2006 GMC Canyon?

Question

Accepted Answer

In order to drain off the engine oil and Oil Filter, lift and support the vehicle and remove the oil fill cap. Clean around the engine oil pan Drain Plug before placing an adequate container beneath oil pan then opening the Drain Plug to drain out the oil. Later, position the container beneath the engine Oil Filter drain defector, make sure old Oil Filter seal is not left on Oil Filter adapter and remove the old Oil Filter using one with a suitable wrench while applying oil to drain into the container. Before fitting it, it needs to be lubricated with clean engine oil and then it should be tightened up to 10 nm (89 inch lbs.) and then rotated an extra 150 degrees. Clean any staying oil from the drain deflector then replace the oil pan Drain Plug tightening 26 nm (19 ft. Lbs.). Once more, lower the vehicle and fill the crankcase with the proper magnitude and kind of engine oil. After fitting the oil fill cap, allow the engine and check the oil pressure gauge and shut off the engine then observe the Oil Filter and Drain Plug mess for any leakage. Finally, take off the oil level indicator and check to see if the oil level is right and adjust if needed.

OEM 2006 GMC Canyon Oil Filter

3 Oil Filters found

2006 GMC Canyon Oil Filter Part Number: 12731179

2006 GMC Canyon Oil Filter Part Number: 12731172

2006 GMC Canyon Oil Filter Part Number: 12690386

2006 GMC Canyon Oil Filter

2006 GMC Canyon Oil Filter Parts and Q&A

Related 2006 GMC Canyon Parts

Alternate Year Models