ChevyParts
My Garage
My Account
Cart
OEM 2001 Cadillac DeVille CV Joint
CV Joint Axle- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 CV Joints found
2001 Cadillac DeVille CV Joints, Front Part Number: 26075588
$269.62 MSRP: $609.63You Save: $340.01 (56%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Joint Kit, Front Wheel Drive Axle; CV Joint; Inner CV Joint; Inner Joint; Inner Joint Assembly
- Position: Front
- Item Weight: 6.00 Pounds
- Item Dimensions: 7.5 x 7.2 x 6.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 26075588
- Warranty: This genuine part is guaranteed by GM's factory warranty.
2001 Cadillac DeVille CV Joints Part Number: 26075596
Product Specifications- Other Name: Joint Kit; CV Joint; Outer CV Joint; Outer Joint; Inner Joint Assembly; Outer Joint Assembly
- Condition: New
- SKU: 26075596
- Warranty: This genuine part is guaranteed by GM's factory warranty.
2001 Cadillac DeVille CV Joint
With a comprehensive array of OEM 2001 Cadillac DeVille CV Joint, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2001 Cadillac DeVille CV Joint are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.
2001 Cadillac DeVille CV Joint Parts and Q&A
- Q: How to replace the outer CV Joint and seal on the wheel drive shaft on 2001 Cadillac DeVille?A: To change the wheel drive shaft outer joint and seal, the larger seal retaining clamp must be cut off the CV Joint with a side cutter and discarded as well as cutting off the smaller seal retaining clamp on the halfshaft bar. Remove the outboard seal and CV Joint outer race and remove the grease from CV Joint inner race . J 8059 snap ring pliers (J 8059) should be used to spread the ears on the race retaining ring and remove the CV Joint assembly from the bar. Remove the seal from the bar and give the taphammer lightly using a brass drift and hammer with the cage of CV Joint to remove all six chrome alloy balls . Keep CV Joint cage and inner race perpendicular with outer race and windows in alignment with the outer race lands. Clean the inner and outer race assemblies, as well as CV Joint cage and balls, using cleaning solvent, so there is no trace of the old grease and contaminants, and then dry the parts. For installation, insert the new swage ring onto the small end of the l joint seal and slip them over the halfshaft bar. To prevent the seal neck to line up improperly, let the new j 41048 small swage tool (J 41048) be mounted into a vise and secure the outboard end of the halfshaft assembly with it. Then tighten the bolts just hand-tight, alternating each bolt until both ends are bottomed. Get hold of a light coat of grease from the service kit to apply on the ball grooves of both inner and outer races, and then set the inner race into the cage without misplacing. Install the cage and inner race into the outer race and put the chrome balls in while packing CV Joint with grease and make sure the outboard seal is in the right shape. Finally push the large diameter of the outboard seal over the CV Joint outer race and crimp the seal retaining clamp using j 35910 earred clamp tool (J 35910), a breaker bar , and a torque wrench to a specification of 176 nm(130 ft. Lbs.), checking the gap dimension on the clamp ear to ensure proper fit.
