OEM 2000 GMC Jimmy ABS Control Module

2000 GMC Jimmy ABS Control Module Parts and Q&A

• Q: How to replace the ABS Control Module in the Hydraulic Control Assembly for Antilock Brakes on 2000 GMC Jimmy?

  A: The first step for bpmv brake pressure modulator valve replacement in the hydraulic control assembly for antilock breaks involves a complete wash of ehcu area contaminants because disassembled abs parts must stay free from contamination. Separate both electrical harness connectors from the ebcm unit while you detach five brake lines from the bpmv component and use tags for traceable reinstallation. The two bpmv mounting bracket bolts need removal before disconnecting the two-way abs pump motor connector and the bpmv mounting bracket from the bpmv. Fourth, use all t-25 torso screws to detach the ebcm unit keeping away from sharp prying actions which could damage it. Extract the ebcm from the bpmv by applying gentle force when needed while using new mounting bolts since reuse of original bolts should be avoided. You should use a clean cloth to clean both ebcm and bpmv mounting surfaces. New mounting bolts should be used for attaching the ebcm device to bpmv while tightening them in an x-pattern to 5 nm (39 inch lbs.). The abs pump motor connector passes through the ebcm before the bpmv receives mounting on the ehcu bracket. Reconnect the two electrical harness connectors to the ebcm and place the brake pipes properly under a frame-mounted plastic bracket to finish reinstallation. Tighten the five brake pipe fittings at the bpmv to 30 nm torque (22 ft. Lbs.). The brake system needs bleeding followed by a diagnostic system check either through (310 ABS) or (325 ABS).