In order to replace the Alternator, it is necessary to first disconnect the negative
Battery Cable and to take off the accessory
Drive Belt. If necessary, remove engine sight shield and disconnect the generator electrical connector. Remove the generator cable from a slot where the boot slides down and reveals the terminal stud removing the cable nut on the terminal stud and the generator cable is taken off. Subsequently, take out the bolts of the generator and take out the generator. For installation, re-position the generator to its location and insert the generator bolts using a torque value of 50 n.m (37 lb ft). Reconnect the generator cable by connecting it and tightening the generator cable nut to the terminal stud to 9 n.m (80lb in), and sliding the boot onto the terminal stud. Connect the electrical connector of the generator, replace the engine sight shield if required, and replace the accessory Drive Belt lastly and reconnect the negative Battery Cable.