The replacement of the underhood electrical center or junction block requires disconnecting the negative
Battery Cable first. A user should begin by lowering the electrical center brace cover while pushing its outboard tabs. Next, they should remove the left fender upper brace. Depress the tab after removing all
Fuses to move the electrical center through the studs positioned at . Separate all electrical connectors by unscrewing the bolt on each one then disconnect the wire ends from the electrical center block. The tabs should be pressed simultaneously to remove the electrical center from its housing. The replacement of engine electrical center bracket requires bolt removal from four retaining positions followed by bracket extraction from the fender. You can integrate the engine electrical center bracket assembly to the front fender through the installation sequence which requires 4 retaining bolts tightened at 9 n.m (80 lb in). Carefully fit the electrical center block stubs into position so that the tabs maintain its place inside the slots before tightening the wire connector bolts at 9 n.m (80 lb in) to the lower electrical center block portion. Connect all wire connectors securely after which set the electrical center block to its resting position to allow tabs to lock in position. After installation of the lower cover part begins the Fuse and relay installation while the cover remains open according to the Fuse location labels. The fender upper brace requires reinstallation while you secure it with the 4 bolts which must be tightened to 25 n.m (18 lb ft). After connecting the negative Battery Cable users must start the vehicle while checking that each component operates correctly.