In order to replace the Catalytic Converter on the right side of the 6.0l engine, start by raising the vehicle. Remove threads for the
Oxygen Sensor connectors and unwrap the exhaust hanger locking left bolts and hanger from the car. Pull off the nuts that hold the
Exhaust Pipe flange to the Catalytic Converter pipe, and loosen off the nut that holds the Exhaust Pipe clamp to the
Muffler. Then, take out the Exhaust Pipe and flange gasket. For installation, the oxygen sensors additionally need to be pulled out and then insert the old ones into the new Exhaust Pipe. Screw them up tightly to 42 nm (31 lb ft). Next, install a new gasket to the Catalytic Converter pipe flange and then attach the Exhaust Pipe to the vehicle. Tighten the nuts on the Catalytic Converter pipe to the Exhaust Pipe unto 48 nm (35 lb ft) and tighten the Exhaust Pipe clamp nut unto 54 nm (40 lb ft). Check the exhaust system clearance and alignment of all parts, then fix the exhaust hanger and bolts, followed by pulling 17 nm (13 lb ft) before lifting the vehicles.