OEM GMC Jimmy Oil Filter

GMC Jimmy Oil Filter Parts and Q&A

• Oil Filter
  19210284
  Q: How to replace the engine oil and oil filter on GMC Jimmy?

  A:

  The first step when replacing engine oil and Oil Filter is to raise then support the vehicle properly. Use a suitable container to drain engine oil by removing the oil pan Drain Plug. The engine Oil Filter removal process starts with the filter extractor from the Oil Filter adapter on 2wd cars and continues to the filter remover applied to the remote Oil Filter adapter for four-wheel drive vehicles. The engine Oil Filter gasket needs to be extracted from its source. You should first apply clean engine oil to the gasket on both 2wd and 4wd Oil Filter adapters before installing the filter securely in its proper place according to the filter instructions. Secure the oil pan Drain Plug into its proper opening in the oil pan by tightening it to 55 nm (18 ft. Lbs.). Lower the vehicle to install the appropriate amount of high-quality engine oil in the crankcase. An engine test with leak-checks and oil pressure inspection will take place followed by closure of the access panel in the steering linkage shield for 4wd vehicles.
• Oil Filter
  19210286
  Q: How to service and repair the oil filter on GMC Jimmy?

  A:

  A vehicle requires lifting before anyone starts servicing and repairing oil filters. Begin service by removing the Drain Plug from the oil pan then drain the engine oil into an appropriate container. Rwd owners should remove the Oil Filter at the Oil Filter adapter but four wheel drive owners must access the remote Oil Filter adapter through the steering linkage shield for removal. The engine Oil Filter gasket needs to be taken off. After wiping the Oil Filter gasket with engine oil and applying oil to the gasket, install the Oil Filter to the rwd Oil Filter adapter or the four wheel drive remote Oil Filter adapter while tightening it per filter instructions. Thread the Drain Plug into the oil pan before tightening it to 25 nm (18 ft. Lbs.). The vehicle must be lowered before filling the crankcase completely with correct engine oil standards. Check oil pressure and monitor for leaks while the engine runs. After checking four wheel drive vehicles, seal the steering linkage shield.