OEM Chevrolet Uplander Door Striker

Chevrolet Uplander Door Striker Parts and Q&A

• Striker
  10352584
  Q: How to replace the rear sliding door striker on Chevrolet Uplander?

  A:

  The first step to replace the rear sliding Door Lock striker involves disabling the power sliding door system through psd 15a fuse removal from the instrument panel fuse block followed by opening the sliding door. You must remove the sliding Door Striker screws before taking out the sliding Door Striker combined with the shim from the c-pillar. Install the sliding Door Striker onto the c-pillar by placing it into the oversized hole which allows 4 mm (0.15 in) of adjustment through the caged nut. The striker may fail to engage the Door Lock properly so check the door alignment within the frame accordingly. A proper alignment will be achieved by placing the door latch at the center of the striker or by adding or removing shims accordingly. When you have the sliding Door Striker positioned correctly you should install its screws and apply 25 n.m (18 lb ft) torque. The psd 15a fuse needs to be reinstalled into the instrument panel fuse block to restore low current logic power after which the power sliding doors will work but the modules need to learn the full open and closed positions.
• Striker
  86785938
  Q: How to replace the front side door striker on Chevrolet Uplander?

  A:

  The first step to replace the front side door lock striker starts with opening the front door where you must sketch out the existing front door lock striker position on the B-pillar using a grease pencil. The sequence starts by unscrewing front door lock striker screws until you can remove the front door lock striker plate together with its accompanying shim from the B-pillar. You should put the front door lock striker plate and shim into place at the B-pillar location marked with pencil grease and fasten the front door lock striker screws to 25 N.m (18 lb ft) torque. The adjustment step requires the front door lock striker to connect correctly to the front door lock before the installation of the door within the frame while using the striker to maintain the door at a level position free from elevation or lowering attempts. Finally, close the front door.