OEM Chevrolet Traverse Power Steering Pump

Chevrolet Traverse Power Steering Pump Parts and Q&A

• Power Steering Pump
  85112727
  Q: How to replace the power steering pump on Chevrolet Traverse?

  A:

  Starting the Power Steering Pump replacement requires first taking off the fuel injector sight shield. Unplug both power steering fluid hose pipelines from the remote power steering fluid reservoir. Collect drained fluid in drain pans underneath the vehicle. First take off the Drive Belt then the steering gear heat shield together with the right side Catalytic Converter from the vehicle. Disconnect both hoses from the Power Steering Reservoir and gear manifold before the Power Steering Pump bolts can be removed to pull out the Power Steering Pump from the vehicle. Lay the Power Steering Pump into its designated vehicle position then install and torque the Power Steering Pump bolts to 50 nm (37 lb ft). Fasten the power steering gear inlet hose fitting to the Power Steering Pump at 27 nm (20 lb ft) torque before attaching the power steering fluid reservoir outlet hose . You should clean all surplus fluid while removing drain pans until you put back the right side Catalytic Converter together with the steering gear heat shield and the Drive Belt. To finalize the process fill the power steering system then perform a bleeding procedure before reinstalling the fuel injector sight shield.