OEM Chevrolet Traverse Camshaft Position Sensor

Chevrolet Traverse Camshaft Position Sensor Parts and Q&A

• Camshaft Position Sensor
  12608424
  Q: How to replace the Camshaft Position Sensor on Bank 2 (Left Side) Intake on Chevrolet Traverse?

  A:

  The first step when replacing the bank 2 (Left Side Intake) Camshaft Position Sensor is to uninstall the engine mount strut bracket. The first step in sensor replacement requires detaching the radiator inlet hose from the water outlet. First remove the bolts that secure the power steering fluid reservoir bracket before moving it to a different position. You will disconnect the electrical connector attached to the engine wiring harness which is connected to the bank 2 intake Camshaft Position Sensor. First separate the sensor bolt from the sensor before taking out the sensor. Begin the installation process by mounting the sensor alongside the bolt with a torque level of 10 nm (89 lb in). The bank 2 intake sensor features a wiring harness electrical connector which needs to be restored throughout the process. The power steering fluid reservoir bracket should be positioned where it will stay by securing its bolts at a torque of 9 nm (8 lb in). The radiator inlet hose should be reconnected to the water outlet while the engine mount strut bracket should be installed last.
• Camshaft Position Sensor
  12684186
  Q: How to replace the Camshaft Position Sensor for Bank 1 (Right Side) Intake on Chevrolet Traverse?

  A:

  The procedure of Camshaft Position Sensor for Bank 1 (Right Side) Intake replacement begins by disconnecting the engine wiring harness electrical connector from the bank 1 intake camshaft position (CMP) sensor and requires removing both the CMP sensor bolt and sensor. When installing the CMP sensor be sure to bolt in place with a torque of 10 Nm (89 lb in). Reattach the engine wiring harness electrical connector first to the bank 1 intake CMP sensor.