How to service the Suspension Control Module on Chevrolet Tahoe?

To service the Suspension Control Module you should remove the right side interior trim panel on your vehicle type. Take off the bolt and the electrical connectors from the module. Slide the module out of the bracket and remove it from the vehicle. For installation, slide in the new module into the bracket and wrench the screw (15mm) at 1.6Nm (14 inch lbs). Resolder the module's electrical connectors. In the case of replacing the module, calibrate by connecting the scan tool to the Data Line Connector (DLC) when the ignition is turned ON with the engine OFF, following the scan tool instruction. Lastly, install the right side interior trim panel which is appropriate for the type of your vehicle.

How to replace the Electronic Suspension Control Module on Chevrolet Tahoe?

You should start by removing the right side interior trim panel when you need to replace the electronic suspension control module in Tahoe, Yukon or Escalade models. Start by removing the module from the bracket after disconnecting its electrical connectors along with removing its screw. Put the new module inside the bracket then fasten the screw before tightening it to 1.6 Nm (14 inch lbs.). You should reattach all electrical connectors to their corresponding location on the module. Module replacement requires special calibration through a scan tool connected to the data link connector and activation of the ignition ON while the engine rests followed by module selection under special functions. Follow the instructions on the scan tool alongside techline terminal to complete rtd module programming from the special functions choice on recalibration. Users should access special functions from the scan tool after programming where they must perform the alc trimset following the instructions displayed on the screen. Complete the right side interior trim panel installation at the end of the procedure.

OEM Chevrolet Tahoe Suspension Control Module

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

9 Suspension Control Modules found

View related parts
Chevrolet Tahoe Control Module Part Number: 84215186
$299.89 MSRP: $542.78
You Save: $242.89 (45%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Module Assembly-Electronic Suspension Control; Suspension Control Module; Module, Electronic Control Suspension
- Replaces: 84072358
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2018-2020 Chevrolet Tahoe | LS, LT, PPV, Premier, SSV | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Control Module Part Number: 25971217
$471.17 MSRP: $852.80
You Save: $381.63 (45%)
ADD TO CART
Product Specifications
- Other Name: Module Assembly-Electronic Suspension Control; Suspension Control Module; Module, Electronic Control Suspension
- Replaces: 15893732
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2008-2014 Chevrolet Tahoe | Hybrid, LS, LT, LTZ, PPV, SSV | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Control Module Part Number: 23201680
$329.84 MSRP: $619.42
You Save: $289.58 (47%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Module Assembly-Electronic Suspension Control; Suspension Control Module; Module, Electronic Control Suspension
- Replaces: 23201678
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2015-2017 Chevrolet Tahoe | LS, LT, LTZ, PPV, Premier, SSV | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
View related parts
Chevrolet Tahoe Control Module Part Number: 15095294
$398.68 MSRP: $773.76
You Save: $375.08 (49%)
ADD TO CART
Product Specifications
- Other Name: Module, Electronic Control Suspension; Suspension Control Module
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2007 Chevrolet Tahoe | LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
View related parts
Chevrolet Tahoe Auto Level Control Part Number: 86827857
$824.34 MSRP: $1485.30
You Save: $660.96 (45%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Module Assembly-Auto Level Control; Compressor; Module, Electronic Control Suspension
- Replaced by: 85648138
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2022 Chevrolet Tahoe | Commercial, High Country, LS, LT, PPV, Premier, RST, SSV, Z71 | 6 Cyl 3.0 L DIESEL, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Auto Level Control Part Number: 84951816
$783.22 MSRP: $1411.20
You Save: $627.98 (45%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Module Assembly, Auto Level Control; Air Suspension Compressor; Compressor; Module, Electronic Control Suspension
- Replaced by: 85648139
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2021-2023 Chevrolet Tahoe | Commercial, High Country, LS, LT, PPV, Premier, RST, SSV, Z71 | 6 Cyl 3.0 L DIESEL, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Control Module Part Number: 25971218
$417.04 MSRP: $748.05
You Save: $331.01 (45%)
Product Specifications
- Other Name: Module Assembly-Electronic Suspension Control; Suspension Control Module; Module, Electronic Control Suspension
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2008-2014 Chevrolet Tahoe | Hybrid, LS, LT, LTZ, PPV, SSV | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Control Module Part Number: 15767446
Product Specifications
- Other Name: Module, Electronic Control Suspension
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2000-2003 Chevrolet Tahoe | Base, LS, LT, Z71 | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
View related parts
Chevrolet Tahoe Control Module Part Number: 15189546
Product Specifications
- Other Name: Module, Electronic Control Suspension
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2004-2006 Chevrolet Tahoe | Base, LS, LT, Z71 | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS

Chevrolet Tahoe Suspension Control Module

Want to cut long-term maintenance and repair costs? Choose OEM Suspension Control Module. Those parts deliver top durability you can trust. On our site, you'll find a huge catalog of genuine Chevrolet Tahoe parts. Prices are unbeatable, so you can keep more in your pocket. Every OEM Chevrolet Tahoe Suspension Control Module includes a manufacturer's warranty. You can also get an easy return policy that keeps buying risk free. Fast delivery, get your car on the road quickly. It's simple to search, compare, and order. Stop guessing about quality or fit. Order today and save with parts that last.

Chevrolet Tahoe Suspension Control Module Parts and Q&A

Control Module
15767446
Q: How to service the Suspension Control Module on Chevrolet Tahoe?
A:
To service the Suspension Control Module you should remove the right side interior trim panel on your vehicle type. Take off the bolt and the electrical connectors from the module. Slide the module out of the bracket and remove it from the vehicle. For installation, slide in the new module into the bracket and wrench the screw (15mm) at 1.6Nm (14 inch lbs). Resolder the module's electrical connectors. In the case of replacing the module, calibrate by connecting the scan tool to the Data Line Connector (DLC) when the ignition is turned ON with the engine OFF, following the scan tool instruction. Lastly, install the right side interior trim panel which is appropriate for the type of your vehicle.
Control Module
15189546
Q: How to replace the Electronic Suspension Control Module on Chevrolet Tahoe?
A:
You should start by removing the right side interior trim panel when you need to replace the electronic suspension control module in Tahoe, Yukon or Escalade models. Start by removing the module from the bracket after disconnecting its electrical connectors along with removing its screw. Put the new module inside the bracket then fasten the screw before tightening it to 1.6 Nm (14 inch lbs.). You should reattach all electrical connectors to their corresponding location on the module. Module replacement requires special calibration through a scan tool connected to the data link connector and activation of the ignition ON while the engine rests followed by module selection under special functions. Follow the instructions on the scan tool alongside techline terminal to complete rtd module programming from the special functions choice on recalibration. Users should access special functions from the scan tool after programming where they must perform the alc trimset following the instructions displayed on the screen. Complete the right side interior trim panel installation at the end of the procedure.