Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2007 Chevrolet Silverado 3500 Classic | LS, LT, WT | 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 8.1 L GAS
| Page 1 of 2 |Next >
1-20 of 28 Results
Chevrolet Silverado 3500 Classic Door Handle
Want to cut long-term maintenance and repair costs? Choose OEM Door Handle. Those parts deliver top durability you can trust. On our site, you'll find a huge catalog of genuine Chevrolet Silverado 3500 Classic parts. Prices are unbeatable, so you can keep more in your pocket. Every OEM Chevrolet Silverado 3500 Classic Door Handle includes a manufacturer's warranty. You can also get an easy return policy that keeps buying risk free. Fast delivery, get your car on the road quickly. It's simple to search, compare, and order. Stop guessing about quality or fit. Order today and save with parts that last.
Chevrolet Silverado 3500 Classic Door Handle Parts and Q&A
Q: How to replace the front door exterior door handle on Chevrolet Silverado 3500 Classic?
A:
Visitors must start the front door exterior handle replacement process by taking off the trim panel and the water deflector. Holiday the lock cylinder rod and outside handle rod from their attached clips. Secure the handle with masking tape before you take off the outside handle mounting nuts along with the rubber cover to reach the outboard nut. Begin by taking away the Door Lock Cylinder from the outside handle housing and afterward remove the handle. When you need to place the handle on the vehicle it should be attached following these steps. A replacement lock cylinder requires gm p/n 12345120 (Canadian P/N 726548) or similar lubricant on the lock case interior with the cylinder keyway before the Door Lock Cylinder installation into the outside handle housing. Moving forward, fasten the lock cylinder rod into its clip while building a connection between the handle rod and handle assembly clip. Use the masking tape to install the two outside handle mounting nuts which must be tightened to reach 9 n.m (80 lb in). The process ends with the reinstallation of both the rubber cover and water deflector as well as the trim panel.
Q: How to replace the rear door handle on Chevrolet Silverado 3500 Classic?
A:
The replacement process for rear door exterior handles begins with first removing trim panel and water deflector. You should first detach the outside handle rod and the lock cylinder rod that are connected through their clip sections. The outside handle mounting should be taped down to secure the handle before you unscrew the outside handle mounting nuts. Then remove the rubber cover to reach the outboard nut and pull out the Door Lock Cylinder from the outside handle housing. According to the manual, fit the new handle onto the vehicle frame after taking out the existing handle. Before installing the Door Lock Cylinder into the outside handle housing apply gm p/n 12345120 (Canadian P/N 726548) or a similar lubricating substance to both the lock case interior and the keyway opening of the cylinder. Fasten the lock cylinder rod with its clip followed by attachment of the handle rod to the handle assembly clip. Replace the masking tape on the Door Handle then tighten the outside handle mounting nuts up to 9 n.m (80 lb in). Replace the rubber cover and water deflector along with the trim panel as the last step.