To change the Starter motor on a v6 engine, first you will have to eliminate the negative
Battery Cable. Then lift, and support the vehicle accordingly. Take out the oil pan skid plate bolts and plate, if there is any. Next is timing the Starter solenoid cable clip bolt out of the frame along with the Starter motor bolts. Unclip the Starter solenoid cable lead nut and remove the Starter solenoid cable lead from the Starter. Also, you lengthily remove the engine wiring harness lead nut and the engine wiring harness lead from the Starter before removing the Starter off the vehicle. In case the Starter shield is banged then it has to be replaced and if Starter then removed Starter heat shield manifestation. For installation if a Starter was replaced attach Starter heat to the Starter, place in the vehicle as well as connect engine lead of the vehicle to the Starter of the vehicle. Apply the engine wiring harness lead nut and tighten it to a torque of 3.4 nm (30 lb in). Next, attach the Starter solenoid cable lead to the Starter and tighten the Starter solenoid cable nut to 9 nm(80lb in). Put up the Starter motor bolts to a tightness of 50 nm (37 lb ft). Install the Starter solenoid cable clip to the frame and tighten the Starter solenoid cable clip bolt to 10 nm (89 lb in). If available, install the oil pan skid plate and tighten the bolts 28 nm (21 lb ft). Last, observe the diminished vehicle and then connect the negative Battery Cable once more.