Service professionals must begin electrical center or junction block replacement by detaching the negative
Battery Cable followed by removal of the left fender upper brace. Clear the tabs on the electrical center brace cover assembly by lifting it outwards before taking out all
Fuses and relays. Use the tab to twist the electrical center on the studs at until all connectors become free by removing their bolt . Push the tabs to detach electrical connectors from the block area of the electrical center and lift the center out of its housing. The replacement of engine electrical center brackets involves using a 4-bolt retaining process to extract the fender-mounted engine electrical assembly. The engine electrical center bracket assembly must be mounted on the front fender following engine electrical center bracket assembly and the 4 retaining bolts must be tightened to 9 n.m (80 lb in). The electrical center block stubs should enter their corresponding slots while the tabs function to keep it situated before the wire connectors are attached to the lower electrical center block portion followed by bolt tightening to 9 n.m (80 lb in). Position the electrical center block properly to lock its tabs before tightening all wire connectors securely. The lower part of the cover gets installed first and afterward follow the Fuse location guide to install all fuses and relays before finishing with the cover. Secure the fender upper brace by tightening all its bolts to 25 n.m (18 lb ft). Check all components by starting the vehicle after reattaching the negative cable.