To replace Heated Oxygen Sensor (HO2S) Bank 2 Sensor 2, initially, lift up and adequately support the vehicle. Remove the connector position assurance (CPA) retainer and remove the HO2S sensor electr cal connector. Remove the HO2S . When installing, also ensure that a special anti-seize compound will be applied to the HO2S threads; this compound includes liquid graphite and glass bead, whereas new or service replacement sensors already contain this. If replacing the old sensor, lubricate the threads with anti-seize compound GM P/N 12377953 or something similar. Install the HO2S and tighten it to 42 N.m (31 lb ft). Next, connect the HO2S electrical connector and the CPA retainer while lowering the vehicle.