OEM Cadillac XLR Washer Pump

Cadillac XLR Washer Pump Parts and Q&A

• Washer Pump
  12335752
  Q: How to Service and Repair the Washer Pump on Cadillac XLR?

  A:

  The replacement process for a headlamp Washer Pump requires first elevating and steadying the vehicle with adequate space between it and the left front fender. Ordinarily detach and document the left front wheel position before you take out the left front lower wheelhouse splash shield fasteners from their position behind the wheelhouse (1, 2, 3). Remember the fender alignment reference for reinstallation. The installation process starts with draining fluid from the lower mounted windshield Washer Pump output hose by disconnecting it before removing the headlamp Washer Pump output hose after sliding out the lock and removing it from the assembly. First remove the electrical connector of the headlamp Washer Pump then turn the Washer Pump counterclockwise to extract it from the washer solvent container. The installer must wet the headlamp Washer Pump body rubber grommet before pushing the pump through the grommet until the pump reaches its original position. To install the headlight Washer Pump electric connection you must attach it to the pump before hooking up the output hose to the pump and locking in place using the sliding connection mechanism. Connect the lower windshield Washer Pump output hose while lowering the vehicle then reposition the washer solvent to its original level. Check washer pumps along with sensor leaks when aligning the fender and installing fasteners (1, 2, 3) to the left front lower wheelhouse splash shield beforeinstallationof the left front wheel.
• Washer Pump
  12335751
  Q: How to replace the headlamp washer pump on Cadillac XLR?

  A:

  Vehicle elevation begins to replace the headlamp Washer Pump by supporting it while clearing space from the left front fender for the hoist. Cut off the left front wheel while removing fasteners 1, 2, 3 away from the rear section of this wheelhouse splash shield so you can note the fender position for reinstallation alignment. The output hose of the lower mounted windshield Washer Pump should be detached and drained into a proper container before removing the slide lock of the headlamp Washer Pump output hose to disengage the pipe. You must first disconnect the electrical connector from the headlamp Washer Pump before twisting the Washer Pump out of the washer solvent container in order to remove it. Before mounting the headlamp Washer Pump body rubber grommet needs to become moist then guide the pump into the grommet until the pump reaches its original position. First mesh the headlamp Washer Pump electrical connector then link the output hose to the pump using the sliding lock mechanism. The vehicle needs to be lowered after reconnecting the washer solvent output hose from the lower windshield pump to refill solvent into the tank. After inspecting washer pumps and the level sensor for leaks the fender needs proper alignment followed by installation of fasteners (1, 2, 3) to the left front lower wheelhouse splash shield before reattaching the left front wheel.