OEM Cadillac SRX Door Check

Cadillac SRX Door Check Parts and Q&A

• Door Check, Rear Lower
  25773003
  Q: How to replace the rear door check link on Cadillac SRX?

  A:

  You must start by taking off the door trim panel followed by detaching the forward section of the water deflector from the door panel to reach the door check link. Begin by disconnecting the door check link bolts at both hinge pillar and door before extracting the door check link through the door opening. Place the door check link into the door opening before tightening the two door check link to door nuts to 9 N.m (80 lb in). Secure the door check link arm to the center pillar bolt but only tighten it to 9 N.m (80 lb in). Reinstall both components of the water deflector along with the door trim panel.
• Door Check, Front
  25812377
  Q: How to replace the front door check link on Cadillac SRX?

  A:

  The first step for front door check replacement requires you to remove the door trim panel. The forward segment of the water deflector needs to be pulled back from the door panel for checking the link. First disconnect the door check from the body bolt and from the door nuts after taking out the check from the door. Start by installing the check into the door while strictly following the instructions in Service Precautions regarding fastener installation. The check nuts need to be secured using 9 N.m of torque while staying within 80 lb in range. Fasten the check arm to the front body hinge pillar bolt and tighten it with the same torque value of 9 N.m (80 lb in). After installation of the door trim panel you need to install the water deflector.