OEM 2010 Cadillac DTS Antenna Cable

2010 Cadillac DTS Antenna Cable Parts and Q&A

• Q: How to replace the digital radio antenna cable on 2010 Cadillac DTS?

  A: When replacing the digital radio Antenna Cable start by dismantling the rear sail panel along with the rear assist handles while being cautious about damaging the headliner. First detach the Antenna Cable from its small metal clips while lowering the rear portion of the headliner. After this remove the Antenna Cable from its connection point on the am/fm Antenna module. You should remove the foam tape which protects the Antenna Cable connections and then separate the Antenna connectors from their radio Antenna links. Begin by adding a wire or string to the Antenna Cable's end before you take off the left rear compartment's trim panel and disconnect the cable from the digital receiver. Pull the Antenna Cable from its clips and rear harness placement before leading the cable through the compartment and taking out the wire or string. To install the system start by connecting a wire or string to the Antenna Cable and slowly feed it through the passenger compartment as you remove the wire or string. Take the Antenna Cable to the digital receiver and set it in the rear compartment's hold-down clips before attaching the Antenna connectors to the digital radio Antenna while using foam tape to encase the connectors. Drill the Antenna Cable through the am/fm Antenna slot then mount it inside roof and third pillar locating clips before replacing the headliner with roof panel and front assist handles and upper rear quarter trim panel.