How to replace the knock sensor for Bank 2 on 2009 Chevrolet Traverse?

Begin by disconnecting the negative battery terminal when replacing the Knock Sensor in bank 2. After removing the engine Oil Filter proceed with the next step. Use a floor jack to lower the vehicle while disconnecting the engine wiring harness electrical connector from the bank 2 Knock Sensor . Thread the Knock Sensor bolt before extracting the Knock Sensor from its position. Install the Knock Sensor in its designated position before securing the bolt to 23 nm (17 lb ft). Connect the engine wiring harness electrical connector to the Knock Sensor of bank 2. First support the vehicle properly before installing a new engine Oil Filter. Reconnect the negative Battery Cable as the last step.

OEM 2009 Chevrolet Traverse Knock Sensor

Engine Knock Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Knock Sensor found

View related parts
2009 Chevrolet Traverse Knock Sensor Part Number: 12729597
$18.81 MSRP: $35.32
You Save: $16.51 (47%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Distributor (Also Knock Sensor); Camshaft Sensor
- Replaces: 12692505, 12605738, 12636736
- Condition: New
- SKU: 12729597
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following 2009 Chevrolet Traverse Submodels:
- High Country, L, LS, LT, LTZ, Premier, RS | 6 Cyl 3.6 L GAS

2009 Chevrolet Traverse Knock Sensor

With a comprehensive array of OEM 2009 Chevrolet Traverse Knock Sensor, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2009 Chevrolet Traverse Knock Sensor are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2009 Chevrolet Traverse Knock Sensor Parts and Q&A

Q: How to replace the knock sensor for Bank 2 on 2009 Chevrolet Traverse?
A: Begin by disconnecting the negative battery terminal when replacing the Knock Sensor in bank 2. After removing the engine Oil Filter proceed with the next step. Use a floor jack to lower the vehicle while disconnecting the engine wiring harness electrical connector from the bank 2 Knock Sensor . Thread the Knock Sensor bolt before extracting the Knock Sensor from its position. Install the Knock Sensor in its designated position before securing the bolt to 23 nm (17 lb ft). Connect the engine wiring harness electrical connector to the Knock Sensor of bank 2. First support the vehicle properly before installing a new engine Oil Filter. Reconnect the negative Battery Cable as the last step.