OEM 2008 Chevrolet HHR Flywheel

2008 Chevrolet HHR Flywheel Parts and Q&A

• Q: How to replace the engine flywheel on 2008 Chevrolet HHR?

  A: Begin engine Flywheel replacement by uninstalling automatic transmission equipment and after that remove start reliefs for manual transmissions with clutch when present. Secure the Flywheel on the engine block using j 43653 (Flywheel Holding Tool) while making sure the chamfered edge of an 18 mm socket has been cut off to facilitate correct fitting of thin-headed Flywheel bolts. Proceed by taking off the automatic transmission Flywheel bolts before disassembling the Flywheel. The automatic transmission Flywheel was balanced at a different time than the engine. A nylon bristle brush should clean thread adhesive residues from the Flywheel bolt holes. Follow the same procedure for manual transmissions by unbolt and remove the Flywheel before cleaning its bolt holes. Installation of the Flywheel begins with manual transmissions by setting the fastener notice and installing the Flywheel bolts then tightening to 53 n.m (39 lb ft) while adding an additional 25 degrees by using the j 45059 (Angle Meter). You need to perform the same steps with automatic transmissions before taking out the j 43653 (Flywheel Holding Tool) from the engine block. Reinstalling the clutch is mandatory when present along with the Starter when using a manual transmission and the automatic transmission when applicable.